Seiskan asennus muistitikulta

eero
Site Admin
Viestit: 329
Liittynyt: 07 Marras 2007 20:17

Seiskan asennus muistitikulta

Viesti Kirjoittaja eero »

Tässä hyvin helpot ohjeet miten asennat esim Windows 7:n USB tikulta, ja nopeasti asentuukin.


First, you’ll need the DiskPart utility on the system you will use to prep the thumb drive. This is a free disk partitioning utility that is likely already installed on your Windows system.
diskpart_setup.exe.txt
Diskpart
(191.65 KiB) Tiedosto ladattu 1030 kertaa
Launch the DiskPart utility by typing diskpart at the Start Menu.
Then run the list disk command to check the status of your drive.
Now run select disk 1 where the "1" is actually the corresponding number of your USB drive.
Run clean.
Once the thumb drive is clean, you can run create partition primary.
Now make the partition active by entering active
Then you need to set up the file system as Fat32 by running format fs=fat32 quick (quick, of course, specifies that you want to perform a quick format to speed up the process).
Entering the assign command gives the USB drive a drive letter, making it easy to access from Windows Explorer
Then you can copy everything from the Windows 7 installation DVD onto the USB key (a simple drag and drop will do).
Now you can insert the thumb drive into the system you want to install Windows 7 onto and boot the system. The installation will now proceed as usual—but faster.

Entä jos muistitikulla on jo fat32? Sinun tulee silti ajaa clean komento ja tehdä partitio uudelleen. Syytä tähän en varmaksi tiedä, ehkä windows tekee samalla paritioon tarvittavat boottijutu. Pelkkä usb muistiosion merkitseminen aktiiviseksi ei siis toimi, vaan partitio pitää tehdä uudelleen ensin.

Joskus sain format komennon kohdalla kummallista virhettä että levyä ei valittu. Tässä tilanteessa on parasta ottaa USB tikku hetkeksi irti, ja aloittaa homma alusta.

Lähde:
http://technet.microsoft.com/fi-fi/maga ... n-us).aspx